Stainless Steel Fan & Motor Assembly for New and Old SWG-4HD & SWG-4HDS Venters

Field Controls SWGII-4HDRMK – Stainless Steel Fan and Motor Replacement Kit for SWG-4HD/SWG-4HDS The Field Controls SWGII-4HDRMK is a stainless steel replacement assembly designed for both new and existing SWG-4HD and SWG-4HDS venting systems. This unit integrates the vent hood, blower wheel, and motor into a single pre-assembled configuration, simplifying field replacement and reducing installation time. Applications: Engineered for power venting of Category I natural gas, LP gas, or oil-fired equipment Compatible with heating appliances that require induced draft via sidewall venting Supports 100% negative pressure venting systems, helping maintain consistent draft Features: All-in-One Assembly: Includes motor, wheel, and housing for direct replacement Material: Constructed from corrosion-resistant stainless steel for use in outdoor or exposed conditions ETL and cETL Listings: Certified for use in gas and oil venting applications under U.S. and Canadian codes Negative Pressure Design: Ensures combustion gases are safely evacuated with no pressurized joints Flexible Installation: Allows use of standard galvanized vent pipe; no sealing of joints required Extended Run Capability: Supports longer horizontal vent lengths than most direct vent or positive pressure systems Technical Specifications: Model: SWGII-4HDRMK Material: Stainless steel Compatible Units: SWG-4HD, SWG-4HDS Certification: ETL listed to UL-378 and UL-705 standards Mounting: Exterior sidewall Draft Type: Induced draft, negative pressure Installation Notes: This replacement module is intended for use by qualified HVAC or mechanical contractors. Proper sizing and electrical configuration must be verified against the connected appliance specifications. Follow all applicable local codes and manufacturer instructions during installation. Field Controls recommends using with their UC1 control kit or approved equivalents for system operation and safety interlock.